[Ill.u.s.tration]

Child's Hood

This is made much in the same way as the doll's hood. Make the back of the hood five inches in diameter, then turn the web and form the side.

Sew around to within four inches of the place of turning on the opposite side and turn again. So continue until the side is sufficiently wide to cover the child's head. Extend this side three inches beyond the desired width, widening on each row of the extended part to give fulness. This widening may be omitted, and the extended part turned back, leaving it perfectly plain, if desired. Trim with rosettes or pompons made of the same material as the hood.

Turn back the extended part and tack to the hood. Sew a pompon or a rosette of yarn over the top of the sewing st.i.tch. For tie-strings, use cord and ta.s.sel, or ribbon.

The hood requires from twenty-five to thirty yards.

[Ill.u.s.tration]

Little Girl's Hat

This requires twenty-five yards of round web. Measure the child's head for the size of the hat. Start the crown in the same way as the circular mat. When it is five inches in diameter, gradually turn the crown, while sewing the next five or six rows.

When the desired width is reached, begin forming the side by sewing one st.i.tch of web into one st.i.tch of the crown, keeping each row exactly under the preceding row until the desired height is obtained; then gradually widen to form the rim, which is three and a half or four inches broad.

Do not widen any on the last two rows, but draw the web a little tighter while sewing to make the edge of the rim roll or turn inward.

Finish with cord and ta.s.sels around the crown, or pompons on the right or left side of the front of the hat.

[Ill.u.s.tration]

Doll's Sweater

This is made of five and one-half yards of flat web cut into pieces of a desired length. Cut three pieces seven inches long for the front. One inch and a half of this will also form the neck. When cutting, clip only one st.i.tch and pull out the ends.

The next two pieces are cut five and one-half inches long and sewed one on each side of the front one inch and a half below the top end. Each succeeding row is made a little shorter to form the shoulder, the shortest pieces forming the outside edges.

Make the back of the sweater in the same way and sew front and back together, leaving one and a quarter inch opening on each side for the sleeves.

The sleeve is made of five pieces, the longest piece being three inches, and the shortest two and one-half inches long. Sew these pieces together to form the sleeve. When sewing it into the sweater, place the longest part at the shoulder seam and stretch the armhole while sewing it in.

[Ill.u.s.tration]

Wristlets

These are made of round or flat web. Each wristlet requires one and one-half yards.

Measure five inches, the length of the wristlet, and turn. Start sewing from this point and sew to the end of the five inches and turn again.

Continue until enough rows are sewed to make the wristlet the desired width, which in this model is two and one-half inches.

[Ill.u.s.tration]

Shoulder Shawl

This may be made of round or flat web, and of any desired size. If the shawl is to be thirty-six inches long, clip the web into pieces of this length and sew them together until the shawl is of the desired width, or the web may simply be turned at the end of each row, then proceed with the sewing.

The fringe for the ends is made by cutting the yarn into lengths twice as long as the desired length of the fringe--that is, if the fringe is to be five inches long, cut the yarn into pieces ten inches long.

Fold each ten-inch piece in two, slip the folded end through a st.i.tch in the end of the shawl and draw the two ends of the piece through the loop thus formed and pull tight.

[Ill.u.s.tration]

Doll's Carriage Robe

This robe is ten inches wide and eighteen inches long, and is made of four pieces of flat web, each piece three yards long. Any number of pieces of either round or flat web may be used, and the robe made wider and longer if desired.

Measure fifteen inches of web and turn it. Begin sewing from this, turn down to the end of the fifteen inches and again turn, bringing the web around over the end. Care must be taken while turning to keep the ends perfectly flat.

When the three yards are used begin the other parts in the same way.

Make four or any desired number of parts, and sew them together, alternating the colors. Put a ta.s.sel made of the same material on the rounded end of each part.

If round web is used it will require more for each part, for the round is not as wide as the flat web.

[Ill.u.s.tration]

Child's Leggings

Leggings may be made of round or flat web. Measure five inches above the knee down to the vamp of the shoe for the length of the front part of the legging. This gives the length of the first row.